Corky | Activity
-
Corky replied to the forum topic Problem with a radial slice planar toolpath in the group
BobCAD-CAM 1 week, 4 days agoAl Thanks so much! I went back and did as you said and it work just fine. I was under the impression that all toolpaths were constrained by the boundry more than the parameters. Thanks again! Corky -
Corky replied to the forum topic Problem with a radial slice planar toolpath in the group
BobCAD-CAM 1 week, 4 days agoAl For some reason I can’t download your file, but I did go back a added the extra surfaces just like you showed, didn’t work. Re-loaded the software twice, as I did find a corrupted tool file. But just now I […] -
Corky replied to the forum topic Problem with a radial slice planar toolpath in the group
BobCAD-CAM 1 week, 4 days agoAl Thanks for your help. I did try several variations of the same solution, but still the same toolpath is generated. I even generated all new geometry and I still get the same results. I rebooted – same. What […] -
Corky started the forum topic Problem with a radial slice planar toolpath in the group
BobCAD-CAM 1 week, 4 days agoHello all! I hope that someone can put me on the right path to generate a simple toolpath. I’m making some die steels that need to have some odd sized corner rounding radii install along the top profile of a […] -
Corky posted a new activity comment 1 week, 5 days ago
Burr thank you for that information, I’ll put it to good use here in a few minutes. CorkyIn reply to - Corky posted an update in the group BobCAD-CAM Forgive me if this post is in the wrong spot, as I’m having a terrible time navigating this site, and Admins feel free to set it in the correct place. Most of our […] · View -
Corky posted an update in the group
BobCAD-CAM 1 week, 5 days agoForgive me if this post is in the wrong spot, as I’m having a terrible time navigating this site, and Admins feel free to set it in the correct place. Most of our little problems we have been able to work out – so far – that is until today. We are machining some die stell for a customer and my problem is how do you profile corner rounding…[Read more]-
@corky This video will show you how to get to a forum to make a topic. http://youtu.be/k1SXfTOqQy4
-
Burr thank you for that information, I’ll put it to good use here in a few minutes. Corky
-
-
Corky joined the group
BobCAD-CAM 1 week, 5 days ago -
Corky joined the group
BobCAD-CAM Support 3 months, 2 weeks ago -
Corky became a registered member 4 months, 1 week ago

