Bob | Activity
-
Bob posted a new activity comment 1 month, 2 weeks ago
Hey, thanks. I was going through all of my set-up and found the clearance plane input area of the stock page. I appreciate you replying.In reply to - Bob posted an update in the group General Discussion How come the clearance plane is greyed-out. I want to set a 1” clearance plane above my job. Any advice welcome… Thx. · View -
Bob posted an update in the group
General Discussion 1 month, 2 weeks agoHow come the clearance plane is greyed-out. I want to set a 1” clearance plane above my job. Any advice welcome… Thx.-
go milling stock, edit, near bottom , clearence plane set it there-
Hey, thanks. I was going through all of my set-up and found the clearance plane input area of the stock page. I appreciate you replying.
-
-
-
Bob posted an update 1 month, 2 weeks ago
Older machine is z axis positive from z zero going down. -
Bob posted an update in the group
General Discussion 1 month, 2 weeks agoCan I get my post to output positive values in z-axis from z zero? Thx. -
Bob posted an update in the group
General Discussion 1 month, 2 weeks agoIs it possible to install a V21 post into V24? If so, how is this possible? I have the V21 post processor CD with the post I need to install into V24, but it’s an executable file for installing automatically into V21. Thx. -
Bob posted an update in the group
General Discussion 1 month, 3 weeks agoany tips, suggestions…? -
Bob posted an update in the group
General Discussion 1 month, 3 weeks agohello, just started with BobCAD and while drawing a test part I am having difficulty figuring out how to snap to the center of a circle. I am proficient with ”other” CAD software so this should be a snap. Get it…?-
add a point at arc center, shift left click a circle or line to get snap points
-
-
Bob joined the group
General Discussion 1 month, 3 weeks ago -
Bob changed their profile picture 3 months, 2 weeks ago
-
Bob became a registered member 3 months, 2 weeks ago
